Friday 2 August 2024

Mama Makes Rotate Mate and Square Attachment

Hi everyone, today I'm sharing another card created using Mama Makes Rotate Mate and Square Attachment. 
Begin by placing a piece of five inch square card, the rotate mate and the square attachment into a stamping platform.

Place your chosen stamp, I used the dragonfly from the Hansie's Garden Bits stamp set, in the bottom left corner of the square. 

Pick up the stamp with the lid of the stamp platform and remove the square attachment. Ink the stamp (I used versafine clair strawberry), and stamp.
Turn the card 90°, reink the stamp and stamp.
Repeat the above twice more, so that you have a dragonfly in each corner.
Replace the square attachment, choose another stamp.  I chose the group of three small flowers. Place the stamp next to one if the dragonflies.

Repeat the above steps until you have four lots of the flowers stamped. I used versafine clair chianti. 

As I wanted the flowers both sides of the dragonfly, I cleaned it and repositioned it after replacing the square attachment.
After removing the square attachment, stamp the flowers following the above instructions.
Replace the square attachment and using a green pen, draw around the inside of the square.

Add the next sized square into the attachment.

Draw around this with the same pen, but leave gaps where the stamped images intrude into the space.

Add the next smaller sized square.


Remove the magnet and position the sentiment in the gap and stamp it.

To finish the card I coloured the flowers and the space between the two borders. Then blended a small border of red ink around the edge of the card before gluing it to a six inch square card blank.

Products used:
Stamping platform
5 inch square card
6 inch square card blank
Versafine Clair - Strawberry, Chianti 
Gelly roll pens
Pencil crayons

Thank you for taking a look. 
Alison 


No comments:

Post a Comment

Creating a card using stencils

Hi everyone, today I'm sharing a step by step guide to creating this card using mainly stencils. To begin I cut a piece of D...